Yamaha RX-V2090 - Manual (Page 15)

15
ANTENNA CONNECTIONS
• Each antenna should be connected to the designated terminals correctly, referring to the following diagram.
• Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide
sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an
indoor one. If you experience poor reception quality, an outdoor antenna may result in improvement.
10dB
0dB
-
PHONO
CD
TAPE 1
TAPE
PB
REC
OUT
AUDIO SIGNAL AUDIO
TAPE 2
TAPE
PB
REC
OUT
AM
ANT
GND
FM
ANT
GND
75 Ω
UNBAL.
MAIN
IN
MAIN CH
MAIN
LEVEL
PRE
OUT
5CH
DISCRT
INPUT
AM loop
antenna
(included)
Indoor FM
antenna
(included)
Ground
Outdoor AM antenna
Outdoor FM antenna
75-ohm/300-ohm
antenna adapter 75-ohm
coaxial cable
300-ohm
feeder
Connecting the AM loop antenna
1 2 3
• The AM loop antenna should be placed apart from the main unit. The antenna may be hung on a wall.
• The AM loop antenna should be kept connected, even if an outdoor AM antenna is connected to this unit.
➀
➁
➂
GND terminal
For maximum safety and minimum interference,
connect the GND terminal to a good earth ground.
A good earth ground is a metal stake driven into
moist earth. Notes:
• When connecting the indoor FM
antenna, insert its connector into the
FM ANT terminal firmly.
• If you need an outdoor FM antenna to
improve FM reception quality, either
300-ohm feeder or coaxial cable may be
used. In locations troubled by electrical
interference, coaxial cable is preferable.
Orient so that the best
reception is obtained.