Yamaha DSP-AX1 - Manual (Page 59)

57
English
1 1 Select the source component you want to preset by using
the input buttons.
2 2 Press and hold LEARN for about three seconds using a
ballpoint pen or similar object.
3 3 Use
%
/
%
to select the name of your component’s
manufacturer.
• You will find the names of most audio-video manufacturers
worldwide in alphabetical order on the display window.
4 4 Press POWER (or any other button) on the remote control
while pointing it at the component to check if you have set
up the code correctly. If the component cannot be
controlled by the remote control, try entering another code
for the same manufacturer.
5 5 Press LEARN to confirm the preset.
• If you want to preset another code for another component
immediately, press ENTER and repeat steps 1 to 4.
1 1 Repeat steps 1 and 2 of the procedure in “Setting the
Manufacturer Code in the Remote Control”.
2 2 Select a Library (component category) by using
%
/
%
.
• There are 12 Libraries to set up a manufacturer code; L:TV,
L:CAB (CABLE), L:DBS, L:SAT, L:VCR, L:DVD, L:LD,
L:CD, L:MD, L:TAP (TAPE), L:TUN (TUNER), *L:AMP.
*L:AMP has three codes; YPC, DSP, and NO. “YPC” should be
selected to operate the DSP-AX1. “DSP” is for operating Yamaha
DSP amplifiers other than the DSP-AX1. “NO” is to clear the main
unit control area functions.
3 3 Repeat steps 3 and 4 of the procedure in “Setting the
Manufacturer Code in the Remote Control ”.
Remote Control Features
Setting the Manufacturer Code in the Remote Control
SYSTEM
POWER STANDBY V-AUX TAPE PHONO
D-TV CBL/SAT TUNER MD CD
VCR 1 VCR 2 VCR 3 LD DVD
LEARN
6CH INPUT
TITLE
ENTER
MENU SOUND DISPLAY
SOURCE
SELECT SEARCH CHAPTER
POWER REC STOP PAUSE PLAY
+ –
/
%
! ! $
* #
$
%
%
%
%
%
6CH INPUT
TITLE
ENTER
MENU SOUND DISPLAY
SOURCE
SELECT SEARCH CHAPTER
%
! ! $
* #
$
%
%
%
%
%
POWER REC STOP PAUSE PLAY
+ –
/
You can control other components by setting a manufacturer code. A code can be set up in each component controol area except for the
OPTN area. The Yamaha code is factory preset for DVD, LD, CD, MD, TUNER, and TAPE (Yamaha for LD, and Yamaha1 for others).
There is no factory preset code on VCR1/2/3, D-TV, CBSAT, V-AUX, and PHONO.
Note:
• If you have already programmed a remote control function to a button, the function takes priority over the set up manufacturer code’s function.
■ Controlling a different component from the source component (input) you selected
Note:
• “ERROR” appears in the display window in the following conditions: when pressing a button other than the cursor and ENTER ; when pressing more than
one button at once; and when one of MACRO ON/OFF , 10KEY/DSP , PARAMETER/SET MENU is switched to another position.
flashes alternately