Zanussi ZBF6124A - Manual (Page 8)

Problem Possible cause Solution
The product temperature is too high. Let the product temperature decrease to
room temperature before storage.
The room temperature is too high. Decrease the room temperature.
The Fast Freeze function is switched
on.
Refer to "Fast Freeze function".
The temperature in the freezer is
too low.
The temperature regulator is not set
correctly.
Set a higher temperature.
TheFast Freeze function is switched
on.
Refer to" Fast Freeze function".
The temperature in the freezer is
too high.
The temperature regulator is not set
correctly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too high. Let the product temperature decrease to
room temperature before storage.
Many products are stored at the same
time.
Store less products at the same time.
Products are too near to each other. Store products so that there is cold air
circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not set
correctly.
Set a higher temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
Technical data
Dimension of the recess
Height 880 mm
Width 560 mm
Depth 550 mm
Rising Time 20 h
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.
8