Zenith DSV-110 - Manual (Page 8)

1 5 1 4
These three work differently and it is impor-
tant to consider the options of each when
adjusting the projector settings.
Antenna
When you adjust your TV to signals from an
antenna you must store each channel in a dif-
ferent program. . The same is true for the pro-
jector TV-tuner. When connected to an anten-
na you assign the different channels to the
programs in the Television Setup Menu. Then
you use the Up and Down arrows in the menu,
remote control or the channel up/down button
on the control panel to switch between chan-
nels.
Cable
When you are connected to a cable system
you have two options. If you have a cable
decoder, you will set your TV to the channel
for the cable, and then use the remote control
for the decoder to switch between channels. If
you do not have a decoder you simply set your
TV up just like you would with an antenna.
This is also the same with the Zenith projec-
tor. You must scroll the channel name in the
TV Settings menu until you find the correct
channel for your cable system. When this
channel has been assigned to one of the pro-
gram numbers you simply select this program
and use the remote control or control panel to
switch between channels.
Satellite
This works similar to the cable decoder. You
select the channel that reads the signals from
the satellite dish. Then use the remote control
of the decoder to switch between channels.
6. Using Your Zenith
projector
6.1 Different program modes
for your Zenith projector
The projector has the following modes of oper-
ation:
• Stand-by mode
•
Normal mode
•
Quick mode
•
Menu mode
•
Pointer mode
•
Blank mode
Stand-by mode (see section 6.3)
In stand-by mode the projector is turned off
and can be turned on by using defined keys.
Normal mode
In normal mode a picture will be shown on
the screen. The mouse will function as a nor-
mal PC mouse.
Quick mode (see section 7.2.4)
Quick mode is used with the interactive
remote control (quick key). You assign func-
tionality for the quick key on the remote con-
trol in the quick menu (see section 7.2.5).
When clicking on the Quick key you will be
able to switch between all the functions you
have selected in this menu.
Menu mode
In menu mode the menu system is activated
and you use the mouse pad and the mouse
buttons on the remote control to navigate in
the menu.
4.1 Using external
speakers
In order to use external speakers with the pro-
jector you will need an amplifier. Connect the
amplifier to the audio out on the projector.
When external speakers are connected, these
can be turned on or off from the projector. To
control the internal speakers, see the section
on adjusting audio settings, section 7.3.2.
Figure 7: Using external speakers
5. Connecting a TV-source
to the projector
A TV-tuner is optional for the
projector (Please consult your
Zenith dealer for availability
of this option).
Note: Requires TV tuner to be installed.
In order to use the projector as a TV output;
connect the TV antenna to the TV connector
on the projector plug panel.
The projector behaves just like a normal TV.
See the menus section 7.2.7 on how to adjust
the TV settings.
There are basically three ways of receiving the
TV signals to the projector:
•
Antenna (Terrestrial)
•
Cable
•
Set-Top box for satellite
Figure 8: Connecting to TV- source