Zanussi ZU 9120 F - Manual (Page 16)

P R 3 3 / 2
C
A
16
5. Place guide (A) on the inside part of the furniture
door, up and down as shown in the figure and
mark the position of external holes. After having
drilled holes, fix the guide with the screws sup-
plied.
20mm
A
50mm
PR166
6. Fix cover (C) on guide (A) until it clips into place.
8mm
PR167
A
B
7. Open the appliance door and the furniture door at
90°. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure.
Remove the squares and drill holes with Ø 2 mm
at 8 mm from the outer edge of the door. Place the
small square on the guide again and fix it with the
screws supplied.
8. Should the lining up of the furniture door be neces-
sary, use the clearance of slots.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
PR168
PR167/1
D
B
9. Fix cover (D) on guide (B) until it clips into place.