beautypg.com

Technical specifications, Installation, Positioning – Zanussi ZU 9120 F User Manual

Page 12

background image

DIMENSIONS

Height

81,5

cm

Width

56

cm

Depth

53,8

cm

POWER SUPPLY VOLTAGE AND FREQUENCY

220-240 V / 50 Hz

TOTAL POWER ABSORBED

100 W

AVERAGE DAILY UNITS ELECTRICITY (*)

0,76 kWh

GROSS CAPACITY

95 l

NET CAPACITY

86 l

STAR RATING

(*)This figure is based on standard test results in accordance with European Standard EN153. Actual con-
sumption will depend on how the appliance is used and where it is located.

TECHNICAL SPECIFICATIONS

12

Warning

IF YOU ARE DISCARDING AN OLD APPLIAN-
CE THAT HAS A LOCK OR CATCH ON THE
DOOR, YOU MUST ENSURE THAT IT IS
MADE UNUSABLE TO PREVENT YOUNG
CHILDREN BEING TRAPPED INSIDE.

Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
under “Door reversal”.

Positioning

The appliance should only be installed at a location
where the ambient temperature corresponds to the
climate classification indicated on the rating plate,
which is located on the inside left of the appliance.
The following table shows which ambient tempera-
ture is correct for each climate classification.

SN

+10°C to +32°C

ST

+18°C to +38°C

The appliance should be located in a dry atmos-
phere, out of direct sunlight and away from continu-
ous heat and extreme temperature, e.g. not next to a
boiler or radiator or in a very cold room e.g. an out-
house. If these temperatures are exceeded i.e.
warmer or colder, then the appliance may not operate
correctly.

INSTALLATION

For building-in and door reversal instructions please
refer to the relevant instructions on the following
pages.

Important
It must be possible to disconnect the appliance

from the mains power supply; the plug must
therefore be easily accessible after installation.