Setup and connections, 5. tv connection - hd monitor (rgb type) – Zenith HD-SAT520 User Manual
Page 30
29
206-3813
3. SETUP AND CONNECTIONS
3-5. TV Connection - HD Monitor (RGB type)
Phone wall jack
HD-Ready TV
Cable TV
wall jack
Antenna
ANT.IN Y
Pb
Pr
L
R
LNB
Sat B
LNB
Sat C
LNB
Sat A
Dish
5x4 Multi-switch
Output
TV Viewing
1. Connect the “OUT TO TV” jack on the DIRECTV
®
High-Definition Receiver to the “ANT IN” jack on your TV using
a coaxial RF cable.
2. Connect the “RGB OUT” jack on the DIRECTV HD Receiver to the “RGB IN” jack of your TV using VGA-type connector.
(The “TYPE” switch must be set toward the “RGB/DVI-HDTV” jacks.)
3. Connect the L/R “AUDIO OUT” jacks on the DIRECTV HD Receiver to the L/R “AUDIO IN” jacks on your TV using
RCA-type cables.
(Note : The RGB OUT jack is available when 480p, 720p, or 1080i display format is selected.)