beautypg.com

Zanussi ZWF 14070 G1 User Manual

Page 16

background image

16

Altering an option or a running programme
It is possible to change some options before

the programme carries it out. Before you make

any change, you must pause the washing

machine by pressing the button

.

Changing a running programme is possible

only by resetting it. Turn the programme

selector dial to «Off» and then to the new

programme position. Start the new programme

by pressing the button

again. The washing

water in the tub will not be emptied out.

Interrupting a programme
Press the button

to interrupt a programme

which is running, the corresponding light starts

to flash. Press this button again to restart the

programme.

Cancelling a programme
Turn the selector dial to «Off» to cancel a

programme which is running. You can now

select a new programme.

Opening the door after the programme has

started
First set the machine to pause by pressing the

button

. The

light flashes and after a

few minutes goes off. The door can be opened.

If it remains lit, this means that the machine is

already heating, that the water level is too high.

In this case the door can not be opened.
If you cannot open the door but you need to

open it, you have to switch the machine off by

turning the selector dial to «Off».
After a few minutes the door can be opened

(pay attention to the water level and

temperature!).
After this procedure, it will be necessary to set

the programme and the options again and then

to press button

.

5

6.2

5

5

5

5

At the end of the programme
The machine stops automatically.

If the «Rinse Hold» or «Night Cycle» option

has been selected, the door remains locked to

indicate that the water must be emptied out

before opening the door.
To empty out the water proceed as follows:
1.turn the programme selector dial to «Off»
2.select the Drain or Spin programme
3.reduce the spin speed if needed, by pressing

the relevant button

4.press the button

to start the selected

programme

5.at the end of programme, only the

light

illuminates. Now it is possible to open the

door.

Turn the programme selector dial to «Off» to

switch the machine off.
Remove the laundry from the drum and

carefully check that the drum is empty.

If you do not intend to carry out another wash,

close the water tap.

Leave the door open to prevent the formation

of mildew and unpleasant smells.

6.3

5

132960380.qxd 22/09/2008 9.09 Pagina 16