Zanussi ZWF 14070 G1 - Manual (Page 14)

Operating sequence
14
Follow the product manufacturers’ instructions
on quantities to use.
Use less detergent if:
●
you are washing a small load,
●
the laundry is lightly soiled,
●
large amounts of foam form during washing.
Degrees of water hardness
Level
Degrees
German
°dH
French
°T.H.
Characteristic
1 0-7 0-15 soft
2 8-14 16-25 medium
3 15-21 26-37 hard
4 > 21 > 37 very hard
Before the first use
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in the
drum, one item at a
time, shaking them out
as much as possible. Close the door.
Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked .
If required, pour fabric softener into the
compartment marked (the amount used must
not exceed the «MAX» mark in the drawer).
Close the drawer gently.
WARNING!
Ensure that the electrical and water
connections comply with the installation
instructions.
IMPORTANT!
Remove the polystyrene block and any
material from the drum.
IMPORTANT!
Pour 2 litres of water into the main wash
compartment of the detergent drawer in
order to activate the ECO valve. Then run a
cotton cycle at the highest temperature, without
any laundry in the machine, to remove any
manufacturing residue from the drum and tub.
Pour 1/2 a measure of detergent into the
dispenser drawer and start the machine.
132960380.qxd 22/09/2008 9.09 Pagina 14