Zanussi ZWF 14070 G1 User Manual

Page 15

Select the required programme by turning

the programme selector dial (

)

Turn the programme selector dial to the

required programme. The green light of button

starts to flash.The selector dial can be

turned either clockwise or anticlockwise.
Position «Off» to Reset programme/Switching

OFF of the machine.

At the end of the programme the selector

dial must be turned to position «Off», to

switch the machine off.
IMPORTANT!
If you turn the programme selector dial to

another programme when the machine is

working, the red light of button

will flash 3

times to indicate a wrong selection. The

machine will not perform the new selected

programme.

Select the spin speed, the Night Cycle or

Rinse Hold option by pressing button
When selecting a programme, the light

corresponding to the maximum speed allowed

for that programme will illuminate (refer to the

section «Programme table» for the maximum

allowed by each cycle spin speed).

Select the desired option by pressing the
buttons and
Depending on the programme, different

functions can be combined. These must be

selected after choosing the desired programme

and before pressing the button

. The

relevant light will light up.
In any case, if an option is chosen that is not

allowed with the selected programme, the red

light of the button

starts flashing.

Start the programme by pressing button
The corresponding green pilot light stops

flashing. The appliance starts operating and

the door is locked.

Press the same button to interrupt a

programme which is running, the

corresponding green pilot light starts to flash.

To restart the programme from the point at

which it was interrupted, press the button

again.

If you have chosen a delayed start, the

machine will begin the countdown.
Select the Delay Start by pressing the

button
If you wish to delay the start, press this button

repeatedly to select the desired delay. The

relevant light illuminates.

You must select this option after you have set

the programme and before you press the

button .

You can cancel the delay time at any time,

before you start the programme.

If you have already pressed the button

and you wish to cancel the delay time, proceed

as follows:
• set the washing machine to PAUSE by

pressing the button

;

• press the button

once, the light relevant

to the selected delay goes off.

• press the button

again to start the

programme.

IMPORTANT!
• The selected delay can be changed only after

selecting the washing programme again.

• The door will be locked throughout the delay

time. If you need to open the door, you must

first set the washing machine to PAUSE by

pressing the button

and then wait a few

minutes until the door lock is released.

After you have closed the door, press the

button again.

The Delay Start can not be selected with

«Drain» programme.

132960380.qxd 22/09/2008 9.09 Pagina 15