Yamaha EM5014C - Manual (Page 26)

26 EMX5014C Owner’s Manual
Front & Rear Panels
Reference
d PFL (Pre-Fader Listen) Switch
Set this switch on if you want to monitor the pre-fade
of the signal that is being output at the ST OUT or ST
SUB OUT jacks. If the switch is on, the signal (prior to
adjustment by the ST master fader and ST SUB con-
trol) is fed to the PFL bus so that it can be monitored at
the PHONES jack.
• The signal level into the PFL bus is not affected by
the settings of the ST master fader and ST SUB
OUT Control.
• The PFL ( G , N , d ) and AFL e switches select
the mix to be monitored at the PHONES jack. If
the channel’s PFL or AFL switch is ON, the chan-
nel’s output is mixed into the monitor signal to the
PHONES jack.
e AFL (After-Fader Listen) Switches
Set this relevant switch on if you want to monitor the
post-fade of the signal that is being output at the ST
OUT or the SEND AUX1 or SEND AUX2 jack. If the
switch is on, the signal (following adjustment by the
ST master fader or AUX1 or AUX2 fader) is fed to the
AFL bus so that it can be monitored at the PHONES
jack.
• The signal levels into the AFL bus are not affected
by the settings of the ST master fader or the
AUX1/2 fader settings.
• The PFL ( G , N , d ) and AFL e switches select
the mix to be monitored at the PHONES jack. If
the channel’s PFL or AFL switch is ON, the chan-
nel’s output is mixed into the monitor signal to the
PHONES jack.
f AUX1 and AUX2 Faders
The AUX1 fader adjusts the level of the output from
the SPEAKERS A jacks h or the SEND AUX1 jack
I. The AUX2 fader adjusts the level of the output
from the SPEAKERS B jacks h or the SEND AUX2
jack I.
g ST Master Fader
Adjusts the level to the SPEAKERS jacks h or ST
OUT jacks S.
• Does not affect the level of the output from the ST
SUB OUT jacks.
• The signal to the SPEAKERS jacks is determined
by the setting of the POWER AMP switch Z .
d
e
g f
NOTE
NOTE
NOTE