Zanussi ZDC 888 - Manual (Page 14)

14
FO 0018
Oven Shelves and Shelf
Supports
To clean the oven shelves and the shelf supports,
soak in warm soapy water and remove stubborn
marks with a well wetted soap impregnated pad.
Rinse well and dry with a soft cloth.
The shelf supports can be removed for easy
cleaning (see diagram). Please, ensure the retaining
nuts are secure when refitting the shelf support.
Grease Filter
To prevent a build-up of fats on the fan impellor, the
grease filter must be fitted by clipping it over the
vents in the back panel.
To clean the grease filter
When the oven has cooled down, remove the filter
by pushing the protruding tongue on the filter upward,
and wash carefully.
The grease filter should be cleaned after every use.
The filter may be washed in a dishwasher on a
65°C wash. If the filter is heavily soiled, place the
filter in a saucepan of water with approximately 1
teaspoon of automatic washing powder or
dishwasher powder. Bring to the boil and leave to
soak for approximately 30 minutes or longer
depending on the degree of soiling. Ensure the
solution does not boil over as it could mark your
hob.
Rinse filter in clear water and dry.
Remember to refit the filter before using the oven
again.
Replacing the Oven Light
FO 0287
If the oven bulb needs replacing, it must comply
with the following specifications:
- Electric power: 15W,
- Electric rate: 230-240 V (50 Hz),
- Resistant to temperatures of 300°C,
- Connection type: E14.
These bulbs are available from your local Service
Force Centre.
To replace the faulty bulb:
1. Ensure the oven is disconnected from the
electrical supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with
the new one.
4. Refit the glass cover.
5. Restore the electrical supply.
F