Zanussi ZHC 935 - Manual (Page 8)

8
If, having followed these instructions carefully, your cooker hood fails to work properly please carry out
the following checks.
SOMETHING NOT WORKING
Symptom
The cooker hood will not start •
Check the hood is connected to the electricity
supply.
•
Make sure the switch is in the ‘ON’ position.
•
The fan speed is set high enough for the task.
•
The grease filter is clean.
•
The kitchen is adequately vented to allow the
entry of fresh air.
•
If set up for recirculation, check that the
charcoal filter is still effective.
•
If set up for extraction, check that the ducting
outlets are not blocked.
Solution
The cooker hood has switched off during
operation •
The safety cut-out device has been tripped.
•
Turn off the hob and then wait for the device
to reset.
If after all these checks, the fault persists, contact
your local Service Force Centre, quoting the
model and serial number.
Please note that it will be necessary to provide
proof of purchase for any in-guarantee service
calls.
In-guarantee customers should ensure that
the above checks have been made as the
engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
SERVICE AND SPARE PARTS
If you require an engineer or spare parts contact
your local Service Force Centre by telephoning:
08705 929929
Your telephone call will be routed to your local
Service Force Centre. For the address of your
local Service Force Centre and further information
about Service Force, please visit the website at
www.serviceforce.co.uk
For general assistance with your appliance or for
further information on Zanussi products please
contact our Customer Care Department.
Customer Care Department
Zanussi
55 - 77 High Street
Slough
Berkshire
SL1 1DZ
Telephone: 08705 727 727*
* calls to this number may be recorded for training
purposes.