Yamaha CC-5 - Manual (Page 28)

E-26
RECORDING
•
When recording important selections, be sure to make a
preliminary test to ensure that the desired material is
being properly recorded.
•
The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
1 2 3 4 5
6 7 8 9 0
CLEAR CALL + TIME PROG
REPEAT CD
BAND TUNER
HALL JAZZ CLUB ROCK CNCT OFF
POWER AUX DAT VOLUME
TAPE
-
b
a
10
+
4 3
5
1
1 1
6, 2 2
2
1 6, 2 2
5
•
Adjusting the VOLUME, BALANCE, TREBLE and BASS
controls and selecting any SOUND PROCESSOR
program have no effect on the recorded sound.
Recording from the CD player (CD
Synchronized Recording System)
1
Select the CD position and load the CD to be recorded.
2
Load a tape into the tape “b” cassette compartment.
*
Wind past the beginning part of the tape on which
recording can not be performed.
3
When recording with the Dolby NR system, set the
DOLBY NR switch to B or C; if not, set it to OFF.
*
For selection of the Dolby B or C position, refer to the
“Dolby B and C Type Noise Reduction” on page 24.
4
Set the REVERSE MODE switch to to record on only
one side, or to for continuous recording on both sides.
5
Press the REC button.
*
The indicator next to the REC button will light up and
the play indicator flash.
6
Press the play button of the CD.
*
Before CD playback begins, recording automatically
begins on side A of the tape.
To stop recording temporarily
1 1
Press the pause button of the CD.
2 2
Press the play button of the CD to resume recording.
To stop recording
Press the stop button of the tape deck.
(At this time, CD playback does not stop.)