Zanussi FLS 1383 W - Manual (Page 6)

1 Programme guide
2 On/Off button
By depressing this button the machine starts operating.
When depressed again, the machine stops.
3 Heavy soil button
By pressing the heavy soil button, the machine will take
in cold water only on programmes with a water
temperature of 50°-60°-95°C (programmes B-C and H).
These would normally be hot or hot and cold.
The water is then gradually heated to the required
temperature. The effect is to improve the overall wash
performance, particularly on biological stains such as
egg, blood and grass stains, and heavily soiled fabrics,
since the longer «cool-soak» phase as the water heats up
provides the right conditions for the powder and the
water temperature to interact, and achieve the best
possible results.
4 Rinse Hold Plus button
Press this button to make the machine stop with water in
the drum after the cotton, synthetic or delicate wash
cycles.
This prevents any creasing which may occur if the
clothes are left damp in the drum. When it is convenient
for you to empty the machine, simply press this button
again so that the machine can proceed to drain and spin,
or turn the dial to the drain programme “P”.
If this button is not activated, the washing programmes
will end with a spin.
Do not press this button for woollens: wool items should
be gently spun.
6
The Control Panel
1 2 3 4 5 6 7 8
A Q U A C Y C L E W A S H S Y S T E M F L S 1 3 8 3 W IMPORTANT : PLEASE READ THE INSTRUCTION BOOK BEFORE USING THIS APPLIANCE
1 2 5 0
Extra prewash
Whites
Fast coloureds
Non-fast coloureds
Hand rinses
Spin 1250 A
B
C
D
F
G Mixed fabrics
Worn once
Wool care
Delicates
Freshen up
Spin 650
Drain H
J
K
L
M
N
P
HEAVY
S O I L ON-OFF RINSE HOLD
P L U S
5 Bio Button BIO
By depressing this button with programmes C and H the
water temperature is maintained at 40°C for additional
10 minutes. During this phase the enzymes in the
detergent develop a greater washing efficiency.
This option cannot be used together with the HEAVY
SOIL button.
6 Spin speed selector dial
The spin speed can be varied as follows:
Cotton & linen: from 1250 (max) to 500 (min) rpm.
Mixed fabrics and delicates: from 650 (max) to 300
(min) rpm.
Wool: from 1000 (max) to 300 (min) rpm.
NOTE: The spin speeds marked on the dial refer to spin
speeds for cotton and linen programmes. To select 650
rpm for mixed fabrics and delicates and 1000 rpm for
wool, the spin speed selector dial should be positioned to
the max. setting (1250).
To select 300 rpm it should be positioned to the min.
setting (500).
7 Mains-on light
This light illuminates when the machine starts working
and goes out when the ON/OFF button is released.
8 Programme selector dial
Turn the dial clockwise to select the required wash
programme.
Before setting the dial to any position the machine must
be switched off by depressing the ON/OFF button again.