Zanussi ZI 9454 X - Manual (Page 17)

17
Height adjustment
The height of the appliance is adjustable by 50 mm.
in order that the lower doors line up with existing
kitchen units.
Before installing the appliance between units, adjust
the height of the feet and rear wheels. The wheels
are factory set for a work top height of 820 mm. To
align the appliance to work top height of 870 mm,
raise it by adjusting the feet with a spanner, then
remove the wheels and refit them in the lowest
position.
Fitting the side panels
• Fit the brackets onto the panels in the positions
shown in the diagram. The dimension of 260* mm
is allowed for fitting a 100 mm plinth below the
panel. For different plinth sizes, increase the
dimension of 260* mm accordingly.
• Rest the panels against the appliance.
• Fit the rear brackets, taking into account the
thickness of the panels (maximum width of unit
900 mm).
• For a correct alignment make sure that the
distance between the appliance and the cabinet
is of 45 mm.
• Secure the panels at the front.
• Check the alignment of the doors loosing the
fixing screws and by means the adjustment
bushes.
• Tighten the clamp screw on the bottom hinges of
the doors.
820
870
POSITIONING
820
870
15
820
15
280
54137,5
520,8
260*
997
82,2
RIGHT HAND
SIDE PANEL
FRONT
EDGE
INSIDE
FACE
REAR
EDGE
27,5
45