beautypg.com

Directions for use – Windsor Zephyr User Manual

Page 8

background image

8

English

2. Directions for use

Wallpaper remover (Order no. 2.863-076)

With the wallpaper remover you can use the steam
cleaner for stripping wallpaper.

Procedure:

– Place the wallpaper remover with its entire

surface on the edge of a sheet of wallpaper.
Allow the steam to penetrate until the wallpaper
is soaked through (approx. 10 sec.).

– Without switching it off, move the wallpaper

remover to a new location. Use a putty knife to
lift the loosened wallpaper, and pull it off
completely.

– The steam may not be able to readily penetrate

woodchip wallpaper that has been painted
several times. In this case we recommend that
you go over the wallpaper with a spiked roller
before steam is applied.

Caddy

6.962-239

Set of circles of bristles
with brass bristles

2.863-075

Set of circles of bristles

2.863-077

Micro-fibre cloth

6.905-921

– As soon as the lamp on the iron extinguishes, it

is ready for use.

– As soon as you press the switch, a solenoid

valve in the main unit opens and steam flows
out of the base of the iron. If you push the switch
forwards, steam is expelled continuously; if you
push the switch towards the rear, shots of
steam are discharged.

– Begin by directing the steam onto a piece of cloth

until water no longer comes out of the iron.

– Turn the steam volume control on the main unit

to obtain the desired amount of steam.

– You can hold the iron vertically for steaming

curtains, clothes, etc.

Dry-ironing

– If you wish to iron without using steam, switch

the steam supply switch on the main unit to ON,
and the heater switch to OFF.

– Set the temperature dial for the desired fabric

type.

Synthetic fibres

Wool

Linen

Window nozzle (Order no. 4.130-145)

Attach the window nozzle directly to the steam

gun. Use the extension tubes if required.

Apply steam evenly to the glass surface from a

distance of approx. 8 in (20 cm). Switch off the
steam supply and squeegee the glass surface in
straight passes from top to bottom. Wipe the
rubber lip and the bottom edge of the window dry
after each pass.