Air conditioner care, Changing air direction, Normal sounds – Whirlpool ACE082XP1 User Manual
Page 11: Cleaning the air filter, Cleaning the front panel, Repairing paint damage, Annual maintenance
11
Thermostat
Turn the THERMOSTAT control to a mid-setting. Adjust the air
conditioner’s performance by turning the Thermostat control
clockwise for maximum cooling. For less cooling, turn the
THERMOSTAT control counterclockwise. Experiment to find the
setting that suits you best.
For heating, turn the THERMOSTAT control counterclockwise.
The electric strip heater is activated when the Fan control is set to
a heat setting.
NOTE: Your air conditioner is not designed to be used as a
primary heat source. It is intended for supplemental heating only.
Changing Air Direction
Use the tabs to direct the air right or left (on some models).
Rotate the whole cartridge to direct air up, down or straight
ahead.
Normal Sounds
When your air conditioner is operating normally, you may hear
sounds such as:
■
Droplets of water hitting the condenser, causing a pinging or
clicking sound. The water droplets help cool the condenser.
■
Air movement from the fan.
■
Clicks from the thermostat cycle.
■
Vibrations or noise due to poor wall or window construction.
■
A high-pitched hum or pulsating noise caused by the modern
high-efficiency compressor cycling on and off.
AIR CONDITIONER CARE
Your new air conditioner is designed to give you many years of
dependable service. This section tells you how to clean and care
for your air conditioner properly. Call your local authorized dealer
for an annual checkup. Remember… the cost of this service call
is your responsibility.
Cleaning the Air Filter
The air filter is removable for easy cleaning. A clean filter helps
remove dust, lint, and other particles from the air and is important
for best cooling or heating and operating efficiency. Check the
filter every 2 weeks to see whether it needs cleaning.
NOTE: Do not operate the air conditioner without the filter in
place.
1. Turn off air conditioner.
2. Using the indents in top of filter door, pull door down. Filter
door is not removable.
3. Slide air filter up and out to remove from the filter door.
4. Use a vacuum cleaner to clean air filter. If air filter is very dirty,
wash it in warm water with a mild detergent. Do not wash air
filter in the dishwasher or use any chemical cleaners. Air dry
filter completely before replacing to ensure maximum
efficiency.
5. Slide air filter down into the filter door. Close filter door.
Cleaning the Front Panel
1. Unplug air conditioner or disconnect power.
2. Remove the air filter and clean it separately. See “Cleaning
the Air Filter.”
3. Wipe the front panel with a soft, damp cloth.
4. Air dry front panel completely.
5. Plug in air conditioner or reconnect power.
Repairing Paint Damage
Check once or twice a year for paint damage. This is very
important, especially in areas near oceans or where rust is a
problem. If needed, touch up with a good grade enamel paint.
NOTE: To reduce paint damage during the winter, install a heavy-
duty cover over air conditioner cabinet. For information on
ordering a heavy-duty cover, see “Accessories.”
Annual Maintenance
Your air conditioner needs annual maintenance to help ensure
steady, top performance throughout the year. Call your local
authorized dealer to schedule an annual checkup. The expense
of an annual inspection is your responsibility.
A. Tabs
A
A. Indents
B. Filter
A
B