Whirlpool ACE082XP1 - Manual (Page 10)

10
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
■ Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Starting Your Air Conditioner
1. Set the Exhaust control. See “Exhaust Control (on some
models).”
2. Set the Fan Control to desired setting. See “Fan Control” for
your model.
3. Turn the Thermostat control to a mid-setting. See
“Thermostat” for your model.
Exhaust Control (on some models)
Set the Exhaust control to CLOSED for maximum continuous
cooling. The Exhaust control set OPEN allows you to draw stale
or smoky air from the room.
■ OPEN—to exhaust room air to the outside
■ CLOSED—to circulate room air
NOTE: The Exhaust control will function only when the Fan
Control is operating.
Style 1—Cool only air conditioner settings
Fan Control
Set the Fan control to the desired setting. When the air
conditioner is operating at Low Cool, High Cool, or Turbo Cool,
the fan circulates air continuously.
■ Turbo Cool—for maximum cooling
■ High Cool—for normal cooling
■ Low Cool—for sleeping comfort
■ Fan Only—to move air continuously without cooling
NOTE: Fan runs on Turbo speed only.
Thermostat
Turn the THERMOSTAT control to a mid-setting. Adjust the air
conditioner's performance by turning the Thermostat control
clockwise for maximum cooling. For less cooling, turn the
THERMOSTAT control counterclockwise. Experiment to find the
setting that suits you best.
Style 2—Heat/Cool Air Conditioner Settings (on some
models)
Fan Control
Set the Fan control to the desired setting. When the air
conditioner is operating at Low Cool, High Cool, Turbo Cool, Low
Heat or Turbo Heat, the fan circulates air continuously.
■ Low Heat—for reduced heating
■ Turbo Heat—for maximum heating
■ Turbo Cool—for maximum cooling
■ High Cool—for normal cooling
■ Low Cool—for sleeping comfort
■ Fan Only—to move air continuously without cooling or
heating
NOTE: Fan runs on Turbo speed only.
■ Power Saver—the fan runs only when cooling is needed. The
fan stops circulating air when the room temperature matches
the Thermostat control setting.
Since the fan does not circulate the room air continuously,
less energy is used but the room air is not circulated as often.
Use Power Saver when you are asleep or away from home.
NOTE: Fan runs on Low speed only.
CLOSED
OPEN