Wharfedale subwoofer WH-S8 & WH-S10 - Manual (Page 4)

USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER
CONNECTING THE SUBWOOFER TO THE SYSTEM
Control Panel of the WH-S8 Subwoofer
① Power Indicator
② Volume Control
③ Crossover Frequency Control
④ Phase Switch
⑤ Auto Power Switch
⑥ Line Level Inputs/ LFE Input
⑦ IEC Mains Input Socket
⑧ Mains Power Fuse
⑨ Mains Power Switch
Before Connecting the Subwoofer
• Level the subwoofer taking care to make sure it sits squarely on all its spikes.
• Switch off you amplifier and all connected source units at the mains.
• Unplug the power cords to all system components if necessary.
• Make sure the subwoofer is disconnected from the mains and that the ON/OFF switch is OFF.
• Before re-connecting your system to the AC power supply, check that all the connections are properly made.
• Check that all speaker terminals are done up tightly.
• Ensure that there are no strands of wire shorting adjacent speaker terminals.
• Signal cables should be properly terminated and fully screened to minimise hum. If you connect your subwoofer via low
level signals inputs, the cable between your control unit or processor and the subwoofer could be quite long so screening is
particularly important. Consult your dealer if in doubt.