Whirlpool Petra Collection User Manual
Page 4
4
Important Considerations
Please read the following instructions thoroughly
Inspection
Please take time to inspect each pedicure spa shipment thoroughly for damages immediately upon
delivery. If damages are found, it is very important to notify the freight driver and indicate extent of
the damages on the bill of lading. If you fail to do so, J&A USA will not be responsible for the
damages and may not be able to make appropriate claims to the freight carrier. Any damage claims
must be filed directly by receiver to the freight carrier.
Electrical Service
Each Foot spa must have its own dedicated 115V, 60 Hz, 15 Amp GFCI protected grounded circuit.
Water Supply
Water supply to the PETRA pedicure spa should consist of a system that will provide both adequate
water pressure and water temperature. All plumbing connections must conform to local codes.
Water Pressure
Normal water pressure of 30 to 120 P.S.I. is required to correctly fill the tub to the proper level.
Back Flow Prevention Device
- For following states: AZ, CA, IL, MN, NE, NV, OR, TX, WA, and WI;
All PETRA pedicure spa are equipped with factory installed Dual Check Back Flow Preventer.
Specification:
Tested and certified to meet ANSI/ASSE standard 1024. CSA certified to standard No.B64.6
Pressure / Temperature
Maximum pressure: 150 psi (10 bars)
Minimum pressure: 10 psi (69kPa)
Working temperature: 33F to 140F constant; intermittent to 180F
(0.6C to 60C sustained; intermittent to 82.2C)
Maximum recommended flow: 15 gpm (571pm)
-For all other states:
As an option, the Dual Check Back Flow Preventer will be factory installed.
* Inquire with governing authorities for local installation requirements.
Drain Facilities
Connect the Foot spa drain to meet local plumbing codes.
Please refer to the installation drawings on pages 9-10.
Foot spa is recommended securely fastened to the floor
Fasten the Foot spa with at least two fasteners.
Installation Summary
The installation must comply with local, state, and federal building, plumbing and electrical codes,
where applicable. A licensed plumber should complete the plumbing of the pedicure spa.
Note: Failure to comply with federal, state or local codes and ordinances will result in warranty being
null and void.