Whirlpool Petra Collection User Manual
Page 13
13
FOR STANDARD WHIRLPOOL SYSTEM USERS ONLY
Maintenance
Keep the screen of the suction inlet free of debris, any blockage of the screen reduces the whirlpool
action and may cause damage to the whirlpool pump motor.
Cleaning/ Flushing the inner whirlpool system
Fill up with warm water up to proper level.
Apply 3 tsp of low foaming dish washing detergent, 1 tsp of the regular bleach into the tub.
Start the whirlpool for 5 min and let it still for 5 min and run again for two minutes.
Drain out the water and fill up again with warm water.
Let it run for 5 minutes
Drain out the water.
Wipe dry with soft cloth.
Warning
DO NOT use if you are diabetic, have poor blood circulation, or if any area of your feet or leg is
inflamed or has open wound/s. Please consult your physician before using, if you have any kind of
fungal infection/s, swelling, fracture or persistent pain.
Assembly of the jet and maintenance
JET VENTURI SLEEVE ADJUSTABLE CARTIDGE JET FACE
Assembly
1) With jet VENTURI and jet body in position, insert the cartridge into the body and lightly press
the jet face until the face clicks into the position.
2) Use finger to rotate the eyeball into position. If the assembly is seated, the eyeball will stay
in the correct position.
Disassembly
Press the eyeball inwards with your thumb. The eyeball will move freely when spring is compressed.
Using the fingers, grasp the edge of the jet and pry the face the body. It will snap out and clean
thoroughly, in jet, body, and cartridge for good maintenance as well as prevention from build up.