weber Summit E 470 - Manual (Page 10)

10
GAS INSTRUcTIoNS
m wArninG: the gas connections of your summit ® gas grill
have been factory tested. we do however recommend that
you leak check all gas connections before operating your
summit
® gas grill.
remove Control Panel
Parts required: Phillips screwdriver and a towel .
A) Remove the burner control knobs
(1) .
B) Open both doors and place a towel on top of the doors . This will protect the control
panel and tops of the doors from getting scratched on the next step .
C) Remove the screws from the underside of the control panel with a Phillips
screwdriver (2) .
D) Tilt the conrol panel forward and lift up and away from the grill (3) (For Summit ®
models with LED features: Be careful not to break or disconnect the wires for the
control panel LED’s) .
E) Place the control panel on the towel covering the door assemblies (4) . ◆
LeAK CheCK PrePArAtion
Check that All burner Valves Are off
Valves are shipped in the OFF position, but you should check to be sure that they are
turned off . Check by pushing in and turning clockwise . If they do not turn, they are off . If
they do turn continue turning them clockwise until they stop, then they are off .
2
3
4
1
the grill illustrated
may have slight
differences than the
model purchased.