Western Telematic MPC-20VS16-3 - Manual (Page 43)

5-12
Basic Configuration
To access the configuration menu for the Invalid Access Lockout feature, proceed as
follows:
• Text Interface: Type /F and press [Enter]. The System Parameters menu will
appear as shown in Figure 5.3. At the System Parameters menu, type 4 and press
[Enter] to display the Invalid Access Lockout configuration menu.
• Web Browser Interface: Place the cursor over the "General Parameters" link on
the left hand side of the screen. When the fly-out menu appears, Click on the
"Invalid Access Lockout" link to display the configuration menu for the Invalid
Access Lockout feature.
The Invalid Access Lockout configuration menus allow you to select the following:
• Lockout Enable: Enables/Disables the Invalid Access Lockout feature.
(Default = On.)
• Lockout Attempts: The number of invalid attempts required in order to activate the
Invalid Access Lockout feature. (Default = 9.)
• Lockout Duration: The length of time that logical network ports will remain locked
when an Invalid Access Lockout occurs. If the duration is set at "Infinite", then ports
will remained locked until the /UL command is issued. (Default = 30 Minutes.)