Troubleshooting – Wilton 2221VS User Manual
Page 15
15
Troubleshooting
Problem
Possible Cause
Remedy
Spindle does not turn.
1. Motor overload protector tripped.
1. Press motor overload reset button.
2. Circuit breaker tripped.
2. Reset circuit breaker.
3. Branch circuit breaker tripped or fuse blown.
3. Reset branch circuit breaker/replace
fuse.
4. Open wire in switch circuit.
4. Repair open circuit.
5. Defective switch.
5. Replace switch.
6. Broken drive belt.
6. Replace drive belt.
Spindle noisy.
1. Damaged spindle bearings.
1. Replace bearings.
2. Worn spline.
2. Replace spline.
Drill stalls.
1. Worn drive belt.
1. Check condition of belt. Replace
if glazed or slipping on pulleys.
2. Excessive feed rate for size of drill and
2. Reduce feed pressure or use cutting
material being drilled. No cutting fluid or
fluid. Use correct cutting fluid.
improper cutting fluid.
Poorly drilled holes.
1. Drill dull.
1. Sharpen drill.
2. Lack of rigidity in hold-down method.
2. Check that all T-slot hold-downs are
tight and that table-lock and drill
head bolts are tight.
3. Speed too fast for material and drill size.
3. Check spindle speed recommen-
dations. Reduce speed if necessary.
4. Feed too fast for material and drill size.
4. Reduce feed rate.
5. No or improper cutting fluid or coolant
5. Use cutting fluid, or change to
being used.
proper fluid or coolant for material
being drilled.
6. Improperly ground drill bit.
6. Check for proper angles and reliefs.
Regrind to proper geometry.
Motor overheating
1. Electrical circuit fault.
1. Check current draw in circuit.
Make sure current draw is the
same as rating on motor plate.
2. Oversize drill.
2. Reduce drill size.
3. Excessive feed.
3. Reduce feed rate.
4. No cutting fluid, or wrong fluid.
4. Use correct cutting fluid for the
material and drill.
Table can not be
1. Lack of lubrication.
1. Lubricate.
raised.
No speed readout.
1. Speed pickup out of adjustment or failed.
1. Adjust gap between speed pickup
and post spindle pulley. If there is
no readout on the LED speed
indicator after adjusting the gap,
replace the speed pickup.