Western Telematic CMS-16 - Manual (Page 52)

Display Port Status /S[P] [Enter] X (1) (2) X (1)
Display Port Diagnostics /SD [Enter] X (1) X (1)
Display Network Status /SN [Enter] X
Display Port
Parameters (Who)
/W[P] [n] [Enter] X (2) X (3)
Set System Parameters /F [Enter] X
Set Network Port Parameters /N [Enter] X
Set RS232 Port
Parameters
/P [Enter] X
Copy RS232 Port Parameters /CP [Enter] X
Connect /C [x] [Enter] X X (4)
Resident
Disconnect (5)
[Enter]+++[Enter] X X
Third Party
Disconnect (6)
/D[/Y] [x] [Enter]
/D[/Y] * [Enter]
X
Erase Buffer
/E[/Y] [x] [Enter]
/E[/Y] * [Enter]
X
Reset Network Port /T [Enter] X
Default & Test /I[/Y] [Enter] X
Save Parameters /U [Enter] X
Upgrade Firmware /UF [Enter] X
(1) Supervisor Mode displays parameters for all ports;
User Mode only displays parameters for the ports allowed by the Port
Password.
(2) To display Port Passwords, include the "P" Option. (Supervisor Only).
(3) A port with "User" command capability can only view its own
parameters. A User Port cannot view parameters for other ports.
(4) A User Port cannot perform a Third Party Connect.
(5) Resident Disconnect: Disconnects your resident port from another
port. Note that the Resident Disconnect Sequence can be redefined via
the Port Configuration Menus.
(6) Third Party Disconnect: Disconnects two or more nonresident ports.
Must be issued from a third port with Supervisor command capability.