beautypg.com

Battery charging, Battery installation, Assembly instructions – Walker MT User Manual

Page 25

background image

Assembly Instructions

23

To fill (activate) battery with electrolyte (if battery has
been shipped dry):

1.

Remove the battery hold down bar, disconnect
the battery cables and lift the battery out of the
tray.

IMPORTANT: Battery must be removed from
the mower before filling with electrolyte.

IMPORTANT: Obtain and use only battery
grade sulfuric acid electrolyte with a 1.265 spe-
cific gravity to activate the battery. DO NOT use
water or any other liquid during initial activation.

2.

Remove the filler caps and carefully fill each cell
until the electrolyte is just above the plates.

3.

After the battery is filled with electrolyte, replace
the filler caps and charge the battery. Refer to
Battery Charging.

Battery Charging

1.

Charge the battery at 15 amps for 10 minutes.
DO NOT exceed 20 amps maximum recom-
mended charging rate. Charge until specific
gravity is at least 1.250. Total charging time
should not exceed one (1) hour.

2.

After charging the battery, adjust the electrolyte
level to the bottom of the vent wells [1/4 to 1/2 in.
(6 to 13 mm) above the plates].

IMPORTANT: DO NOT overfill the battery.
Electrolyte will overflow through the vented caps
onto parts of the machine and WILL result in
severe corrosion.

3.

Install battery.

Battery Installation

IMPORTANT: Make sure battery is securely mount-
ed in the frame. A loose battery may cause damage
to the case resulting in acid leakage and severe dam-
age to the machine. A hazard may be created by
damage to critical working parts and safety systems.

Install the battery in the mower as shown in Battery
Installation
photo. Connect the positive and nega-
tive cables to the proper battery terminal (red cable
and boot connects to the Positive (+) terminal)
.
Slide the rubber boot up and over the battery post,
making sure it covers the post completely to pre-
vent an electrical short.

DANGER

Battery electrolyte is a poisonous and cor-
rosive sulfuric acid solution.

Avoid spillage and contact with skin,

eyes, and clothing - causes severe burns.

To prevent accidents, wear safety gog-

gles and rubber gloves when working with
electrolyte.

Neutralize acid spills with baking soda

and water solution.

DANGER

BATTERIES PRODUCE EXPLOSIVE GASES

Charge the battery in a well-ventilated

area, so that gases produced while charg-
ing can dissipate.

Keep sparks, flames, and smoking mate-

rials away from the battery at all times.

Make sure the battery cap vents are

open after the battery is filled with acid
(check manifold vent on each cap).

Make sure the battery charger is unplug-

ged before connecting or disconnecting
cables to the battery.

This manual is related to the following products: