Wilton 41002 - Manual (Page 10)

10
Installing Disc Table
1. Position the disc table at an angle, as shown
in Figure 3, and slide the table on so that the
trunnion slots fit over the raised tracks on
the disc guard.
2. Install a flat washer onto each of the two
remaining handles. Insert the handle into the
holes through the left and right trunnions.
See Figure 4.
3. The gap between the sanding disc and the
disc table should be a maximum of 1/16”. If
it is larger than this, loosen the two socket
head cap screws on the disc guard (one is
shown in Figure 4) and slide the disc guard
to achieve this gap measurement.
4. When finished, tighten the two socket head
cap screws securely.
Installing Miter Gauge
Insert the miter gauge bar into one end of the
miter slot in the disc table. See Figure 5.
The miter gauge can be used in either direction
in the slot to achieve the most effective
positioning of the workpiece against the abrasive
disc.
Installing Tension Handle
1. Place the 1/4” hex nut onto the threads of
the tension handle.
2. Screw the tension handle into the hole on
the hub, then tighten the hex nut against the
hub. See Figure 6.
Figure 3
Figure 4
Figure 5
Figure 6