Wolf Appliance Company Drawer Microwave User Manual

Page 9

Dimensions in parentheses are in
millimeters unless otherwise specified.

I N S TA L L AT I O N

I N S T R U C T I O N S

A N T I - T I P

B L O C K

I N S T A L L A N T I - T I P B L O C K I N G

To reduce the risk of tipping of the drawer, the
Anti-Tip block must be properly installed
located 14

" (376) above the floor on which

the drawer microwave will sit. The 6" (152)
Anti-Tip block must be provided by the
installer. See pages 6–7. The Anti-Tip block
prevents serious injury that might result from
spilled hot liquids.

If the drawer microwave is ever moved to a
different location, the Anti-Tip block must also
be moved and installed. When installed to the
wall, make sure that the screws completely
penetrate the dry wall and are secured in wood
or metal so that the block is totally stable.
When fastening, be sure that the screws do not
penetrate electrical wiring or plumbing.

E L E C T R I C A L

R E Q U I R E M E N T S

E L E C T R I C A L O U T L E T L O C A T I O N

The electrical requirements are a 120 volt 60
Hz, AC only, 15 amp or more protected electri-
cal supply. It is recommended that a separate
circuit serving only this appliance be provided.

The drawer is equipped with a 3-prong
grounding plug. It must be plugged into a wall
receptacle that is properly installed and
grounded. Should you only have a 2-prong
outlet, have a qualified electrician install a
correct wall receptacle.

NOTE: If you have any questions about the
grounding or electrical instructions, consult a
qualified electrician or service person.

(102)

(127)

Electrical Outlet

Location

Anti-tip

Block

(153)

Electrical Outlet

Anti-tip block

I M P O R T A N T
N O T E

You must follow
all National
Electrical Code
regulations. In
addition, be aware
of local codes and
ordinances when
installing your
service.