Wolf Appliance Company Drawer Microwave User Manual

Page 5

I N S TA L L AT I O N

I N S T R U C T I O N S

U N PA C K I N G

Y O U R M I C R O W A V E

Remove all packing materials from inside
the drawer microwave. Do not remove the
waveguide cover, which is located on the
top of the drawer microwave.

Remove the feature sticker, if there is one.
Check the drawer for any damage, such as
misaligned or bent drawer, damaged
drawer seals and sealing surfaces, broken
or loose drawer guides and dents inside the
cavity or on the front side of the drawer. If
there is any damage, do not operate the
drawer microwave and contact your dealer
or a Wolf authorized service center.

Refer to the illustrations below.

C L E A R A N C E S

A N D D I M E N S I O N S

Dimensions shown on the following pages
must be used. Given dimensions provide
minimum clearance. Locate electrical outlet
in the shaded area in the upper left-hand
corner of the cutout. See page 9.

Contact surface must be solid and level. Pay
special attention to the floor on which the
drawer microwave will sit. The floor of the
opening should be constructed of plywood
strong enough to support the weight of the
oven, about 100 pounds (45 kg).

Check location where the drawer
microwave will be installed for proper elec-
trical supply.

Your oven can be built into a cabinet or wall
by itself or under a gas or electric wall
oven.

Be sure that the clearance of the floor
between the wall oven and the drawer
microwave is a minimum of 2" (51).

The microwave interior will easily accom-
modate a 9" (229) x 13" (330) oblong dish or
a bag of microwave popcorn.

The trim will overlap cabinetry by

" (10)

at the top,

" (3) at the bottom. The 24"

(610) will overlap cabinetry by 1" (25) on
each side. The 30" (762) will overlap cabi-
netry by

" (19) on each side.

Dimensions in parentheses are in
millimeters unless otherwise specified.

Waveguide cover

Sealing surface

Oven cavity

Waveguide cover location

Sealing surface location