Wolfgang Puck BBLFP050 - Manual (Page 7)

12
8 Pull the Power Cord out out of the Storage
Cavity at the rear of the Motor Housing.
Ensure that the cord is over the larger
opening in the cord storage area and not in
the locked position, see figs. 10 and 11.
9 Insert the plug into the wall outlet.
If after plugging the cord in, all indicator
lights are flashing, the Mixing Bowl and/or
the Lid is not placed correctly on the Motor
Housing. For safety reasons it is not possible
to switch on the appliance in Food
Processor Mode UNLESS both bowl and Lid
are properly assembled. Check the position
of the bowl and the Lid and ensure that it
matches Figures 7 & 9. When the Mixing
Bowl and the Lid are fitted correctly, only
the Standby Indicator Light flashes. Only
then can the appliance be operated.
10 Press the P(ulse) button to have the Motor
Housing run for a short period at high speed
(pulse function) or press the I button for
continuous low speed or the II/FROZEN
DRINK button for continuous high speed.
The Standby Indicator Light will dim and the
blue indicator light for the selected speed
will be illuminated.
1 1 Add ingredients during use via the Food
Chute in the Lid. Use the Food Pusher to
push solid ingredients downwards through
the chute opening.
12 Use the Food Pusher to close the Chute
opening during use so that nothing can fall
into or splash out of the Mixing Bowl.
13 You can turn the motor off by pressing the
Selected Speed button or if using the
P(ulse) button, simply remove your finger
from the button. Switch the power off by
pressing the power switch, located on the
right side of the Motor Housing and unplug
from the wall outlet.
11
Figure 12 Figure 10
Figure 11
Using Your Food Processor
cont.
Using Your Food Processor
cont.
Locked
Released
14 Remove the Mixing Bowl by rotating counter clockwise and lifting
straight up. Remove the Processing Blade with the Accessory Shaft
from the bowl before emptying.
• Your electronically-controlled motor comes equipped with an
automatic overload protection system which serves two
functions:
1) Time Protection: After two minutes of continuous operation,
the motor will shut off. Fifteen seconds before switching off, the
Standby Indicator Light will begin to flash. This prevents the
motor from overheating during use; and
2) Overload Protection: In the event of an electrical overload, the
motor will automatically shut off. Simply unplug the unit from the
outlet. Wait at least 15 seconds before using again.
• To avoid personal injury or damage to the appliance, never insert
a hand or another object into the Mixing Bowl while the appliance
is being used.
• Always use the Food Pusher to push ingredients. Never use your
fingers, a fork or another object to push ingredients.
• Do not remove the Lid from the Mixing Bowl before the
Processing Blade has stopped moving.
• To remove the Processing Blade from Accessory Shaft, press the
two side lock tabs in, and carefully the lift the blade off the Shaft.
See Figure 12.
HSN_3n1BlenderManual 6/25/10 11:06 AM Page 11