Wolfgang Puck BBLFP050 - Manual (Page 6)

10
1 Place the appliance on a flat, stable, level
surface where it cannot fall.
2 Place the Mixing Bowl on the Motor Housing
with the handle at a 90 degree angle (see
Figure 6). Rotate the Mixing Bowl clockwise
as far as possible until you hear it click into
place (See Figure 7).
3 Slide the Processing Blade over the
Accessory Shaft and push it downwards
until the locks into place.
CAUTION: Be careful when attaching and
removing accessories. The Processing Blade
is sharp.
4 Place the assembled blade and
Accessory Shaft over the drive shaft in the
Mixing Bowl.
5 Place your ingredients into the Mixing Bowl.
6 Place the Lid on the Mixing Bowl as show in
Figure 8 and rotate the Lid clockwise as far
as possible. The Lid’s protruding lip must be
slide over the Mixing Bowl’s handle (See
Figure 9).
7 Place the Food Pusher into the Food Chute.
Figure 6
Figure 7
Figure 8
Figure 9
9
Blender Helpful Hints
• Do not place any utensil (spatula, fork, etc.) in the Blender container
while the Blender is operating. If you need to scrape ingredients
from the sides of the jar, first stop the Blender and wait for the
blades to completely stop moving.
• When blending solid foods, always cut them into no larger than
1-inch pieces before placing them into the jar. Blend no more than
1/2 cup of these foods at a time for uniform blending.
• Remember that ice cubes vary in size and shape. Smaller ice cubes
can be chopped or crushed faster than larger ones. To add ice cubes
to mixtures while the Blender is operating remove the Filler Cap and
drop through the opening. Never attempt to crush ice utilizing your
Food Processor Bowl. As a general rule, add no more than 3 cups of
ice to 4 cups of liquid.
• If too much food is blended at one time, the motor may stall. If this
happens, stop the Blender, turn switch off, unplug from wall outlet,
remove a portion of the food and repeat the blending process.
• Always add liquid ingredients first, followed by solid ingredients.
• To add food or liquid while the Blender is operating, remove the
Filler Cap from the Blender Lid and drop the ingredients through the
opening. Remember to replace the Filler Cap when you have finished
adding the ingredients.
• Avoid over-blending. Usually, you will need to blend for only a few
seconds, not minutes.
• This Blender is not intended to do any of the following tasks: grind
meat, mash potatoes, whip cream, knead dough, whip egg whites, or
serve as a juice extractor.
• Never place any of the following ingredients into the Blender jar:
bones or large pieces of solidly frozen foods or coffee beans. If the
food cannot be cut with a knife, do not place in the Blender jar.
Using Your Food Processor
with Chopping Blade
HSN_3n1BlenderManual 6/25/10 11:06 AM Page 9