Worth Data RF Terminal 7000 - Manual (Page 23)

Date & Time Setting
Set Time
The time is set using a 4-digit military hhmm format. For example, to set the time to 3:08 p.m., you would enter
1508. To display the time during operation, press the STATUS key.
Set Date
For correct date display, the 6-digit date must be set in the date format you plan to use. By default the US
terminals use the US date format of dd/mm/yy. If you change the date format, you must re-set the date to
match the new format. For example, to set a date of January 20, 2009, you would enter 012009 (US format)
or 200109 (European format). To display the date during operation, press the STATUS key.
Date Format
US Format 0
European Format 1
• The US format of mm/dd/yy is the default setting.
• If you switch formats, you must reset the date (SET DATE) in the new format also.
Year Output
2 digit 0
4 digit 1
• By default, the RF Terminal is configured to display and transmit the year in a 2-digit format; i.e. 2009
would transmit and display as 09.
• Before you change the RF Terminal to display a 4-digit year, i.e. 2009, make sure that the software receiving
data from the RF Terminal is set up to accept a 4-digit year.
Shut Down Time
By default, if the RF Terminal is inactive (no keystrokes or scanning) for more than 5 minutes, it will
shut itself down in order to conserve batteries. This includes SIGNING OFF if appropriate. To resume
operation, you must turn the RF Terminal back on using the ON/OFF key. To change the amount of time
the RF Terminal waits before shutting down enter two digits - the default is 05 (5 minutes)- to
correspond to the length of time in minutes. For example, 01 would be 1 minute. Setting the Shut Down
Time to 00 will disable automatic shutdown.
Speaker Settings
Speaker Options
Beep Volume
OFF 1
Low 1
Medium 1
High 1
The default volume of the “Beep” is Medium. Each time you press the “1” key you will hear a
beep at the different volume settings. When you are happy with the loudness of the beep tone, press 0