Install steam boiler controls, Weil-mclain 88 water and steam boilers — series 2, Igure – Weil-McLain 88 User Manual
Page 28
Weil-McLain 88 Water and steam boilers — Series 2 —
for Gas, Light Oil, & Gas/Light Oil-Fired Burners
28
Part No. 550-100-068/1009
Install steam boiler controls
(continued)
Float-type water level control locations
&IGURE
0RIMARY
CONTROL
#ASTING
HEIGHT
BOTTOM
GLASS
"ACK UP
CONTROL
#ASTING
HEIGHT
BOTTOM
GLASS
Note 1
"A"
Notes 1, 2
"B"
¼"
.ONE
—
1½"
½"
-$
(see Note 3)
2
6 "
.ONE
—
2"
150
¼"
2
6 "
¼"
2
6 "
¼"
(see Note 3)
2"
.ONE
—
2"
¼"
2"
¼"
2"
¼"
(see Note 3)
1"to 1¼"
.ONE
—
Notes:
Other manufacturer's controls providing similar function may be used, if properly
1.
located and selected.
Use low water cut-off function only. Pump controller function must only be handled
2.
by the primary control.
When pump control is used with feedwater tank, install pump control on boiler and
3.
make-up water feeder on tank. Use separate low water cutoff on boiler when back-
up is needed. Do not install combination low water cutoff and feeder as back-up
control on boiler. Feeder will operate before pump control operates.