Customer support, Technical specifications, Fcc and ic statement – Wayne-Dalton Z-WAVE HA14WD User Manual

Page 6

FCC and IC Statement

FCC Regulatory Information:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct

the interference by one or more of the following measures:

a) reorient or relocate the receiving antenna,

b) increase the separation between the equipment and receiver,

c) connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

IC Regulatory Information:

This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations. Operation

is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation of the device.

Cet appareillage numérique de la classe B répond a toutes les exigences de l’interférence canadienne causant des règlements

d’équipement. L’opération est sujette aux deux conditions suivantes: (1) ce dispositif peut ne pas causer l’interférence nocive,

et (2) ce dispositif doit accepter n’importe quelle interférence reçue, y compris l’interférence qui peut causer l’opération peu

désirée.

WARNING: Changes or modifications to this receiver not expressly approved by Wayne-Dalton Corp. could void the user’s

authority to operate this equipment.

For Assistance, you may reach us online at www.wayne-dalton.com/access

Printed in China

Part No. 0002906 Rev. A New 09/23/08

CUSTOMER SUPPORT

For Installation and Z-Wave programming support,
please e-mail: [email protected]

Additional product information and general information on Wayne-Dalton Home Control
products may be found on our web site at www.wayne-dalton.com/access.

Compliance/Customer Support/

technical Specifications

TECHNICAL SPECIFICATIONS

• For control of permanently installed incandescent lamp fixtures only.

• Ratings: 600 Watts tungsten, 40 Watts minimum, 120 VAC, 50/60 Hz

• De-rating: 500 Watts double gang, 400 Watts triple gang

• Operating temperature range: 32°F - 104°F/0°C - 40°C