Wilton 7015 - Manual (Page 6)

6
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or
possible machine damage.
This means that if precautions are not heeded, it may result in serious injury or possibly
even death.
Introduction
The Wilton Model 7015 Horizontal Cut-off Bandsaw is designed for high production cut-off work. Four
cutting speeds and a hydraulic feed control allow the efficient cutting of virtually any material.
The Model 7015 Horizontal Cut-off Bandsaw is equipped with a coolant system that can greatly extend
blade life and speed the cutting of a variety of materials that are best cut with cutting fluids and coolants.
Specifications
Model Number ........................................................................................................................................ 7015
Capacity
Rectangular Stock .............................................................................................................8 x 12.9 Inches
Round Stock.............................................................................................................................. 8.9 Inches
Flat Stock ..............................................................................................................................8 x 10 Inches
At 45 Degrees .........................................................................................................................8 x 8 Inches
Speeds ....................................................................................................................... 82, 132, 170, 235 FPM
Motor ................................................... 1 1/2 Horsepower, Capacitor Start, 1725 RPM, 1 Phase, 115 /220V
Blade Size ...............................................................................................................1 x 0.035 x 114.5" inches
Blade Guides..................................................................Tungsten carbide tip & ball bearing, eccentric shaft
Material.................................................................................................................... Tungsten carbide inserts
Sides ............................................................................................................Eccentric shaft, ball bearings
Blade Wheel ......................................................................................................12 inches diameter, cast iron
Dimensions (LWH)
Length .....................................................................................................................................62.5 inches
Width .......................................................................................................................................22.4 inches
Height ............................................................................................................48.4 inches (cutoff position)
Weight ................................................................................................................. Approximately 551 pounds
Vise ........................................................................................................ Rapid acting, screw tightening vise
Coolant Pump .........................................................................................1/8 Horsepower, 1Phase 115/220V