Weider WESY93190 - Manual (Page 18)

46. Locate one of the preassembled pairs of Pulley
Plates (31) and remove both 3 1/2Ó Pulleys (82).
Route the High Cable (85) around a 3 1/2Ó Pulley (82)
in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the Pulley Plates (31) with a
3/8Ó x 2 1/4Ó Bolt (99) and a 3/8Ó Nylon Locknut (42).
Note: The end of the Pulley Plates (31) with two
holes should be pointed downward. Orient the
wide tab on the Pulley Covers as shown.
47. Wrap the High Cable (85) around a 3 1/2Ó Pulley (82)
in the direction shown. Attach the Pulley to the indi-
cated bracket on the Top Frame (2) with a 3/8Ó x 2Ó
Bolt (50) and a 3/8Ó Nylon Locknut (42).
48. Thread a 1/2Ó Plain Nut (98) onto the end of the High
Cable (85). Place a 1/2Ó Washer (68) and a 1 1/4Ó x
1/2Ó Weight Spacer (32) on top of the Weight Tube
(25).
Thread the end of the High Cable (85) into the upper
end of the Weight Tube (25) until the Weight Spacer
(10) touches the Weight Tube.
Note: It is necessary to lift the Weight Tube (25) with
the Top Weight (24) slightly to thread the High Cable
(85) in place.
49. Wrap the Low Cable (86) around a 3 1/2Ó Pulley (82)
in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the Ab Upright (1) with a 3/8Ó x
3 3/4Ó Bolt (76), two 3/8Ó Washers (38) and a 3/8Ó
Nylon Locknut (42). Do not overtighten the Nylon
Locknut; the Pulley should turn easily. Make sure
that the Cable is between the Pulley and the post,
and that the Pulley Covers are oriented as shown.
18
49
46
47
48
85
42
94
82
31
42
Post
1
86
Wide Tabs
38
38
76
94
82
94
End with two
holes should
be down
50
82
2
42
85
98
24
85
68
32
25
Wide Tab
99