Weider WESY49202 - Manual (Page 14)

14
27. Locate the Low Cable (23). Route the Low
Cable under a 90mm Pulley (15). Attach the
Pulley to the M10 x 95mm Bolt (not shown) in
the Press Frame (17) with an M10 Nylon
Locknut (21). Be sure that the end of the
Cable with the ball is on the indicated side
of the Press Frame and that the Cable is
between the Pulley and the crossbar on
the Press Frame.
28. Remove the 90mm Pulley (15) from the lower
hole in the Front Upright (42). Wrap the Low
Cable (23) around the Pulley and reattach the
Pulley to the Front Upright (42) with an M10 x
95mm Bolt (88) and an M10 Nylon Locknut
(21). See the inset drawing. Be sure that
the Cable Trap (66) is turned to hold the
Cable in place and that the Cable is routed
around the Pulley as shown.
29. Route the Low Cable (23) around the 90mm
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable
Trap (66) is turned to hold the Cable in
place and that the Cable is routed around
the Pulley as shown. Tighten the M10 Nylon
Locknut (21) and the M10 x 85mm Bolt (not
shown).
30. Remove the indicated 90mm Pulley (15) from
the Front Upright (42). Wrap the Low Cable
(23) around the Pulley and reattach the Pulley
and Cable Trap (66) to the upper hole in the
Front Upright with an M10 x 95mm Bolt (88)
and an M10 Nylon Locknut (21). See the
inset drawing. Be sure that the Cable Trap
is turned to hold the Cable in place and
that the Cable is routed around the Pulley
as shown.
30
27
23
28
Inset shows view
from other side
29
CABLE ASSEMBL
Y
21
17
Ball
42
88
23
23
21
15
15
42
66
Inset shows view
from other side
42
88
23 23
15
15
66
42
21
23
17
66
15
15
Crossbar
21