Walker PERFAERATORTM PA6685 - Manual (Page 9)

Safety Instructions
7
12. Disengage the PTO clutch when transporting
the machine.
13. Do not operate across the face of slopes. Use
extreme caution when changing direction on
slopes.
14. Never adjust tine depth with the engine run-
ning. Before adjusting tines or servicing, disen-
gage the PTO clutch, stop the engine, and
remove the ignition key. Wait for all movement
to stop before getting off the seat.
NOTE: The PTO brake should normally stop
drive line rotation within 5 seconds of disengag-
ing the PTO clutch.
15. Do not operate the aerator with the covers open.
16. If the aerator tines do not move when the PTO
is engaged:
a. Disengage the PTO clutch, stop the engine,
and remove the ignition key before leaving
the seat.
b. LOOK to make sure PTO shaft and the tine
movement has stopped before servicing
any area of the machine.
c. Disconnect the fuel solenoid wire [diesel en-
gines] or spark plug wire(s) [gasoline en-
gines].
17. If the implement strikes a solid object or the ma-
chine begins to vibrate abnormally, immediate-
ly disengage the PTO clutch, stop the
engine, and wait for all moving parts to stop.
Disconnect the fuel solenoid wire [diesel en-
gines] or the spark plug wire(s) [gasoline en-
gines] to prevent accidental starting.
Thoroughly inspect the implement and repair
any damage before restarting the engine and
operating the machine. Make sure implement
components are in good condition and all bolts
are tight.
18. Do not touch the engine or muffler while the
engine is running or immediately after stop-
ping the engine. These areas may be hot
enough to cause serious burns.
19. When leaving the machine unattended, disen-
gage the PTO clutch, stop the engine, and re-
move the ignition key.
MAINTENANCE
NOTE: Refer to the Walker Rider Lawnmowers
OWNER’S MANUAL for proper tractor mainte-
nance procedures.
1. To prevent accidental starting of the engine
when servicing or adjusting the machine, re-
move the key from the ignition switch and dis-
connect the fuel solenoid wire [diesel engines]
or the spark plug wire(s) [gasoline engines].
2. To reduce fire hazards, keep the engine free of
grass, leaves, excessive grease, and dirt.
3. Keep all nuts, bolts, and screws tight to ensure
the machine is in a safe, working condition.
4. Perform only maintenance instructions de-
scribed in this manual. Unauthorized mainte-
nance operations or machine modifications
may result in unsafe operating conditions.
5. If the engine must be running to perform a main-
tenance adjustment, keep hands, feet, and
clothing away from moving parts. Do not
wear jewelry or loose clothing.
6. Always use proper engine service manuals
when working on the engine. Unauthorized
maintenance operations or modifications to the
engine may result in unsafe operating condi-
tions.
7. Altering the machine in any manner which ad-
versely affects its operation, performance, dura-
bility, or use will VOID the warranty and may
cause hazardous conditions.
8. Never attempt to disconnect any safety devices
or defeat the purpose of these safety devices.
9. Do not change the engine governor settings or
overspeed the engine. The governor has been
factory-set for maximum-safe engine operating
speed.
10. Use genuine factory replacement parts.
Substitute parts may result in product malfunc-
tion and possible injury to the operator and/or
others.
IMPORTANT: Keep all applicable manuals
immediately accessible to anyone who may
operate or service this machine.