Walker PERFAERATORTM PA6685 - Manual (Page 11)

Assembly Instructions
9
SETUP INSTRUCTIONS
The PERFAERATOR™ is shipped partially assem-
bled. After uncrating, initial setup is required.
NOTE: During the process of unpacking, any dam-
aged or missing parts should be noted and reported
to the delivering carrier immediately (put in writing
within 15 days). The carrier will provide directions
for proceeding with a claim to receive compensation
for damage.
Lift Lever Installation
The lift lever for the camshaft assembly position is
partially assembled. Stand the lift lever upright and
attach the remaining hardware.
Install Lift Lever Handle
(stand upright and insert hardware)
Installation on Tractor
1. Remove the mower deck from the tractor if nec-
essary. Refer to the appropriate Tractor
Owner's Manual.
2. Lightly grease each tractor support arm (2) on
the tractor.
Attach Aerator to Tractor
3. Engage the aerator frame tube sockets on the
tractor support arms. Slide the implement
hitch onto the support arms approximately 3 in.
(76 mm).
Connect Driveline Coupler to Tractor PTO
4. Connect the aerator driveline to the tractor PTO
shaft by sliding back the locking collar on the
yoke, then push the yoke over the PTO shaft
until the locking collar snaps back fully. Make
sure the driveline is well secured at both ends.
5. Install the hitch pin through the hole on the end
of each support arm to lock the hitch in place.
Two (2) hitch pins are included in the owner’s
packet of materials.
Lift Lever
DANGER
This shaft turns at very high RPM. If the
collar is not locked to the PTO shaft at the
tractor end, or if the yoke at the aerator
end is not secured properly, the driveline
can fly loose with great force capable of
causing serious injury or death.
Mounting
Tubes
Only use PTO U-Joint
Tube P/N 7275-15
(9.06 in. OAL)