Weiman Products Deva 100 - Manual (Page 24)

HearthStone Quality Home Heating Products Inc ® Model 8220
24
G LASS
Do not operate the stove with a broken door
glass. Do not abuse the fuel loading door by
striking or slamming it.
When necessary, the glass can be cleaned with
low alkaline content commercial stove glass
cleaners, which are available from your local
dealer. Never attempt to clean the glass while
the fire is burning or the glass is hot. Following
the instructions provided with the cleaner can
clean most deposits. To clean heavier deposits,
remove the door from the cookstove and lay the
it face down on a workbench or table. Apply
the cleaner to the glass and allow it to set for a
few minutes. By laying the door flat, it will
allow the cleaner to penetrate rather than
running off the surface of the glass. Wipe the
cleaner off with a soft cloth.
Important: scratching or etching the
glass will weaken the integrity of the
glass. Do not use a razor blade, steel
wool, or any other abrasive material to
clean the glass. Use low alkaline content
cleaners only.
The fuel loading door glass is a ceramic, shock-
resistant glass, made specifically for use in
wood-burning stoves. Do not use any
replacement glass other than the ceramic glass
manufactured and supplied for use in this
cookstove. Replacement glass is available
through your local dealer.
The fuel loading door glass should be replaced
immediately if broken. Contact your local
dealer for replacement glass, which is
accompanied with instructions and everything
needed for the repair. If you replace the glass
yourself, wear work gloves and safety glasses.
The procedure for the fuel loading door glass and glass
gasket replacement is as follows:
1. Remove the top hinge straight up and away from
the stove.
2. Remove the door by pulling it up and away from
the stove.
2. Place the door face down on a flat, smooth
surface.
3. Apply penetrating oil to the 2 screws in the
retention frame. Remove the 2 screws. Separate
the cast iron window frame from the door.
4. Carefully lift the damaged glass from the door
and discard.
5. Peel the paper backing from the tape gasket.
Apply the new gasket to the new glass as
illustrated above.
6. Place the gasketed glass onto the door.
7. Screw the window frame back on the door.
8. Install the door.
M
AINTENANCE OF THE G LASS C OOK T OP
Be sure utensils have no rough spots to scratch
the surface. Be sure the surface is clean before
the fire is started. Avoid spills and boil-overs by
turning down heat to lowest possible setting for
cooking task, and by using large enough pan.
Wipe up wet spots promptly, being careful to
avoid steam burns. Don't cook with foil on the
glass cook top. It could be damaged by foil
melting onto it. Cover pans to prevent spatters.
C
LEANING OF THE G LASS C OOK T OP
Special care should be taken when removing hot
substances. Turn off all surface units affected by
the spillover and remove the hot pans. Wearing
an oven mitt to hold the scraper, scrape the spill
to a cool area of the cook top and use a paper
towel to remove any excess. Do not continue to
use the soiled area until all the spillover has
been removed. A couple of recommended cook
top cleaners are:
Weiman Cooktop Cleaning Creme
Cera Care
Hopes Cooktop Cleaning Creme
Cerama Bryte "