Weiman Products Deva 100 - Manual (Page 16)

HearthStone Quality Home Heating Products Inc ® Model 8220
16
2) Locate and remove the four bolts that
hold the block-off plate on the back of
the stove. Remove the plate.
3) Place the flue collar on the back of the
stove over the rear flue exit with the
gasket side towards the stove. Rotate the
collar so the 3 chimney connector screws
are easiest to access when necessary to
install later. Replace the four bolts using
the 10mm wrench.
4) Place the cover plate over the flue exit
on the top of the stove, using the same
four bolts that were removed.
C ONNECTION TO A M ASONRY C HIMNEY
Consider two primary elements when
connecting your stove to a masonry chimney:
the chimney itself and the thimble where the
stovepipe connects to the chimney. Use only
Code approved masonry chimneys with a flue
liner.
Before connecting to a masonry chimney, hire a
professional to examine the chimney for cracks,
loose mortar, and other signs of deterioration
and blockage. If the chimney needs repair,
complete the project before installing and using
your stove. Do not install your stove until the
chimney is safe for use.
Make sure the chimney’s cleanout is complete
and working properly. To avoid a loss of draft,
the cleanout must close off completely. If
allowed to cool, your stove will perform poorly
and creosote will build up in the chimney.
Make sure the size of the chimney’s flue is
appropriate for this stove and that it is not too
large. Use a masonry chimney with an 8" x 8"
(203 mm x 203 mm) tile size for best results.
An oversized flue will contribute to the
accumulation of creosote.
Use the following checklist to ensure that your
masonry chimney meets these minimum
requirements:
Chimney wall construction:
‰
Brick or modular block at least 4" (102 mm)
thick.
‰
A rubble or stone wall at least 12" (305 mm)
thick.
Flue liner:
‰
Minimum thickness of 5/8" (16 mm).
‰
Installed with refractory mortar.
‰
At least 1" (25 mm) air space.
‰
An equivalent flue liner must be a listed
chimney liner system meeting type HT
requirements or other approved material.
Interior chimney requirements:
‰
At least 2" (51 mm) clearance to
combustible
structure
‰
Fire stops must be installed at the spaces
where the chimney passes through floors
and/or ceiling.
‰
Insulation must be 2" (51 mm) from the
chimney.
Exterior chimney requirements:
‰
At least 1" (25 mm) clearance to
combustible structure.