Tilting the table, Height scale adjustment – Wilton JWBS-16B User Manual
Page 15
15
Tilting the Table
1. Disconnect the machine from the power
source, unplug.
2. Loosen the lock knobs (A, Fig. 13).
3. Tilt table up to 45 degrees to the right, or up to
10 degrees to the left.
4. Tighten the lock knobs.
Note: Table stop bolt (B, Fig. 13) must be removed
to tilt table to the left.
Height Scale Adjustment
1. Disconnect the machine from the power
source, unplug.
2. The upper blade guide should be set about 1/8”
above the material to be cut.
3. Measure from the table top to the bottom of the
blade guides, Figure 14.
4. Set the indicator to this measurement on the
height scale. Grasp the end of the indicator (C,
Fig. 15) between your finger, and thumb. Move
the indicator into position.
Figure 13
Figure 14
Figure 15