Wolfgang Puck BFPR0040 - Manual (Page 9)

16
Disassembly of Your
Food Processor
.
figure 14 Warning! Always wait for the Chopping Blade
to stop moving completely before removing
the Cover.
1 Remove the Processing Bowl Cover by
turning counter-clockwise and lifting
straight up.
2 If using the Chopping Blade, remove the
Spindle with Chopping Blade attached.
Depress the two flexible tabs located just
above the Chopping Blade and press in
while pushing the Chopping Blade up.
See figure 15.
3 If using one of the Processing Discs, remove
first by grasping the center plastic section
of the Disc. See figure 16. Lift straight up to
remove, then remove center shaft.
4 To remove the Work Bowl, grasp the handle
and turn counter-clockwise to the 3 o’clock
position and lift straight up.
Only grasp under lip
figure 16
Only grasp by center
plastic section
figure 15
Depress flexible tabs
15
Processing More than 4 Cups
Warning! Blades are razor sharp; always handle discs by the white
center rim, not by the blade itself.
5 Place Cover onto Processor Bowl and lock into place. Ensure that
the Food Chute door is in the up position to allow your ingredients
to exit out of the Ejector Chute during processing. See figure 12.
6 Always cut and load food flat-side down into the Food Chute. Insert
the Food Pusher into the Food Chute and apply slight pressure while
holding the PULSE button down to process the food. (See “Helpful
Hints” for more processing.) When the Food Chute is empty, release
the PULSE button. It’s normal for a small piece of unprocessed food
to be left between the Slicing/Shredding Discs and Bowl Lid.
7 Remove the Lid, and then remove the disc before removing the
work bowl. Remove the work bowl by turning counter-clockwise and
lifting straight up.
Warning! Blades are razor sharp; always handle discs by the white
center rim, not by the blade itself (See figure 14).
continued
HSN_4CupFoodProcManual08_2 8/22/08 1:32 PM Page 15