Wolfgang Puck BFPR0040 - Manual (Page 6)

10
Assembling Your Attachments
figure 9
8 Fit the Processing Cover to the Processing
Bowl (see figure 10), and place the Food
Pusher in the Feed Tube.
9 Plug the power cord into a 120V AC power
outlet.
10 Start processing using the CONTINUOUS
ON or PULSE button.
11 When processing is complete, remove the
Spindle and Blade from the Processing
Bowl before removing the processed food.
Warning! Make sure motor has stopped
completely before removing cover. If machine
does not stop within four (4) seconds from
turning power off call 800-275-8273 for assistance.
Do not use machine.
Always turn machine off from Power button,
NEVER use the lid as a means of turning the
machine on or off.
figure 10
continued
9
Assembling Your Attachments
Note: All attachments must be firmly attached
to the Spindle. Always adjust the attachments
until you are sure that they are correctly fitted.
5 Place the Chopping Blade over the
Spindle until it snaps into place. See figure
5. The top of the Chopping Blade has a
rim. Be sure to slide with rim side up onto
Spindle. Refer to figure 6 for correct
placement of the Chopping Blade onto
the Spindle.
Note: If Chopping Blade is incorrectly
placed onto Spindle (see figure 7), use a flat-
tipped screwdriver or other blunt instrument
to depress the flexible side tabs in order
to release the Blade from the Spindle.
See figure 8.
6 Place the assembled Spindle/Chopping
Blade onto the Drive Shaft, see figure 9,
next page. Ensure that the Spindle
assembly is fully seated into the Drive
Shaft. You should not see any of the metal
stem on the bottom of the Spindle if it is
properly assembled. It may be necessary
to turn the Spindle slightly left or right.
7 Place ingredients into the Processing Bowl.
figure 5
figure 6
figure 7
CORRECT PLACEMENT
WRONG PLACEMENT
figure 8
HSN_4CupFoodProcManual08_2 8/22/08 1:31 PM Page 9