Wolfgang Puck BFPR0040 - Manual (Page 5)

8 7
Before Your First Use
Before you assemble the Food Processor,
ensure that the power cord is unplugged.
1 Place the Motor Base facing you on a dry,
level surface.
2 Place the Processing Bowl onto the Motor
Base, the bowl will only sit correctly on the
base when the handle is at the 3 o’clock
position, see figure 1.
3 Rotate the handle clockwise to lock, as
indicated by the graphics on the left side
of the motor base. The Bowl Handle should
be at the 6 o’clock position, see figure 2.
4 Place the Lid on the Processing Bowl
with the tab on the Lid to the right of the
handle. See figure 3. Ensure that the center
pin of the Lid is inserted into the hole on
the shaft. Turn the Lid clockwise until it
engages the interlock on the handle.
See figure 4.
Note: Your Food Processor will not operate
unless your bowl and lid are assembled properly.
Warning: Use caution, as blades are
extremely sharp. Always handle all blades by
their central plastic section. Never grasp the
cutting blade itself.
figure 1
figure 2
figure 3
figure 4
Prior to using your Food Processor, wash all parts as outlined in the
section “Care and Cleaning.”
Assembling Your
Food Processor
Overload Protection
Reset Switch
Your 4 Cup Food Processor is equipped with an overload protection
switch. Should your food processor stop working, unplug it from the wall
outlet. Wait for the motor to cool down (about 5 minutes) and follow the
instructions below.
figure a
1 Ensure that your Food Processor
is powered off and unplugged from the
wall outlet.
2 Remove the Storage Drawer from the
Motor Housing
3 Locate the red RESET button located
underneath the Motor Housing (see figure
a) Press the button in completely.
4 Assemble your Food Processor according
to the instructions in the section
“Assembling Your Food Processor. Plug the
food processor into the wall outlet. Your
Food Processor is now ready to for use.
HSN_4CupFoodProcManual08_2 8/22/08 1:31 PM Page 7