Whirlpool 3977631 - Manual (Page 8)

8
INSTALLATION INSTRUCTIONS
Exhaust requirements
Your dryer must be properly vented to
achieve maximum drying efficiency.
WARNING:
To reduce the risk of fire, this
dryer MUST BE EXHAUSTED OUTDOORS.
• Do not exhaust dryer into a chimney, a wall,
a ceiling, or a concealed space of a building.
• The diameter of the heavy metal vent must
be 4 in.
• Do not use an exhaust hood with a
magnetic latch.
If using an existing exhaust system, remove
accumulated lint.
1. Disconnect vent from the dryer and clean
one section at a time until you reach the
exhaust hood.
2. Use the hose attachment on your
vacuum, or a pole with a feather duster
or rag attached, to clean out lint.
3. Make sure exhaust hood is not plugged
with lint. Be sure the flapper on the
outside end of vent moves freely.
Clean exhaust vent periodically, depending
on use, but at least every 2 years, or when
installing your dryer in a new location.
w WARNING
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions
can result in death or fire.
3977631 v12 c51 3/22/99 5:11 PM Page 8