Wayne 352205-001 - Manual (Page 6)

Troubleshooting Chart
Symptom Possible Cause(s) Corrective Action
Pump won’t run
Motor hums but
pump won’t run
Pump runs but
pumps very little
or no water
Pump cycles too
frequently
6
Operating Instructions and Parts Manual
www.waynepumps.com
1. Check all connections
2. Check battery and replace if low or defective
3. Make sure nothing is interfering with operation of switch
4. Check internal fuse located inside the control box. Pull the
charger from the wall outlet and remove. If the fuse is blown,
replace it with a 20 amp automotive type fuse
1. Check battery and replace if low or defective
2. Unplug pump, remove screen, and check to see if impeller is free
to turn. If impeller is locked, remove the 7 screws on the bottom
of the pump to release the housing around the impeller. Remove
the obstruction. Reassemble pump and reconnect
1. Check to make sure check valves installed between primary
pump discharge and Backup Sump Pump are functioning
properly
2. Check for obstruction and clear if necessary
3. If discharge is too high, a separate line may be required with a
lower discharge height
4. Check battery and replace if low or defective
1. Check to make sure check valves installed between primary
pump discharge and Backup Sump Pump are functioning
properly
1. Connections not secure
2. Low or defective battery
3. Float switch stuck
4. Defective or blown fuse
1. Defective battery
2. Impeller is locked
1. Check valve missing or improperly
installed
2. Obstruction in discharge pipe
3. Discharge pipe length and/or
height exceeds capacity of pump
4. Low or defective battery
1. Check valve problem