Walker MC (20 HP) - Manual (Page 6)

4
ITEM PART DEScRIPTION NO.
NO. NO. REQ’D
ITEM PART DEScRIPTION NO.
NO. NO. REQ’D
Use only genuine Walker ® replacement parts. Effective Date 06-15-10
BODY / cHASSIS ASSEMBLY (GHS MODELS)
Seat Assembly
1 5103 Seat 1
2 7203 Seat Spring Plate 1
3 7223-1 Compression Spring 2
4 7845 Rubber Bumper (1.375 OD x .63) 2
5 7846 Washer (3/8 ID x 1-1/4 OD x 1/8) 2
6 5841-1 Retainer Washer 2
7 7440-5 Shock Mount (1-1/4 x 3/4) 2
Rear Bumper Assembly (GHS 10.0 Bushel Models Only)*
8 5566 Tilt Stop Strap 2
9 5516-9 9.5 Rear Bumper, GHS 1
10 7516-5 Catcher Pivot Bushing 2
11 5162 Roller Wheel (5" Rubber) 2
12 6100-17 Bumper Riser Bar 2
13 7517-2 Catcher Pivot Plate 2
Body Assembly
14 6100-16 Welded Body 1
15 5989-3 Dome Plug (5/16) 2
16 5989-4 Dome Plug (3/8) 2
17 7146 13mm Ball Stud 2
18 5145 Gas Spring Assembly 1
(Includes Items # 17 & 19)
19 7147 Spring Clip 2
20 6101-2 Body Alignment Pivot Mount 1
21 5180 Edge Molding, Lever Opening 2
22 5989-5 Dome Plug (7/16) 1
23 NS Body ID Plate 1
Tilt-Up Latch Assembly Δ
24 5847 Plastic Tip 1
25 5744-20 Spring Arm, Tilt-Up Latch 1
26 5744-10 Spring Pivot Bushing 1
27 5744-15 Compression Spring (3/8 x 5/8) 1
28 5744-13 Mount Angle, LH 1
29 5744-12 Hook, Tilt-Up Latch 1
30 5744-14 Mount Angle, RH 1
chassis Assembly
31 5845 Rubber Bumper (1.50 OD x 1.25) 3
32 5517-10 Bumper Mount 1
33 5267-1 Retainer Collar (1") 1
(Includes Item # F413)
34 5270-1 Pivot Bearing 2
35 5420-2 Tail Wheel Fork 1
36 5037-1 Bearing, Tail Wheel 2
37 5035 Tail Wheel & Tire Assembly (13 x 6.50-6) 1
5035-1 Tail Wheel Tire (13 x 6.50-6) **
5036 Tail Wheel & Hub (6 x 4.5) **
38 5038-1 Axle Spacer Tube (6-5/8) 1
39 6389 Splash Guard 1
40 6307-1 Chassis Frame 1
41 5075-1 LP Wheel & Tire (18 x 8.50-10) 2
5075-2 LP Tire (18 x 8.50-10) **
5075-5 LP Wheel (10 x 7) **
5033-6 Wheel & Tire (18 x 7.00-8) ***
5030-6 Standard Tire (18 x 7.00-8) **
5031-2 Standard Wheel (8 x 5.5) **
5030-4 Tire Tube (18 x 8.50-8) **
Fasteners
F002 10-24 Keps Nut 8
F004 1/4-20 Keps Nut 2
F009 5/16-18 Whiz Locknut 14
F012 3/8-16 Keps Nut 2
F013 3/8-16 Whiz Locknut 2
F014 3/8-16 ESNA Nut 4
F016 1/2-13 Self-Locking Nut 1
F020 5/16-18 ESNA Nut 1
F026 10-24 x 1/2 PPHMS 4
F027 10-24 x 5/8 PPHMS 2
F029 1/4-20 x 1/2 Hex Bolt 4
F040 3/8-16 x 1-1/2 Hex Bolt 2
F042 3/8-16 x 2-1/4 Hex Bolt 2
F048 1/2 SAE Washer 2
F051 3/8 SAE Washer 2
F059 3/8 Wave Spring Washer 2
F085 3/16 Rivet Backup Washer 2
F087 #10 x 7/8 Fender Washer 4
F091 5/16-18 x 5/8 Hex Bolt 1
F093 5/16-18 x 1 Hex Bolt 5
F131 5/16-18 x 1/2 Hex Bolt 2
F151 3/8-16 x 7/8 Hex Bolt 2
F157 1/2-20 x 1-1/4 Wheel Lug Bolt 8
F183 .312 x .700 x .074 Washer 2
F206 #2 x 3/16 Drive Pin 2
F213 3/4-10 Jam Nut 1
F227 3/8 x 1-1/4 x 1/8 Plastic Washer 2
F241 .375 x .875 x .10 Washer 4
F257 3/8 x 1-11/16 Shoulder Bolt 2
F292 1/2-13 x 8-1/2 Hex Bolt GR 2 1
F341 Coil Roll Pin (7/64 x 9/16) 1
F342 5/16 Conical Washer 2
F413 5/16-24 x 5/16 Set Screw 2
F480 3/4-10 x 1-1/4 Hex Bolt 1
* Rear Bumper Assembly for GHS 6.7 Bushel Models is not
shown here. Refer to BODY ASSEMBLY (GHS 6.7 BUSHEL
MODELS), Page 6. Rear Bumper Assembly for SD Models is
not shown here. Refer to BODY ASSEMBLY (SD MODELS),
Page 8.
** Service Part Only
*** May be ordered as a factory-installed option or for dealer in-
stallation. Narrow Drive Tires are used when installing a 36"
Deck. Contact your Walker dealer.
Δ Complete Tilt-Up Latch Kit available by ordering kit P/N 5747.