Western Telematic Data/FaxModem - Manual (Page 14)

Command Function/Options
&Fn Loads a read-only (non-programmable)
factory configuration.
&F0 Generic template
* &F1 Hardware flow control template
&F2 Software flow control template
&Gn Sets Guard Tone.
* &G0
No guard tone (U.S. and Canada)
&G1 550 Hz guard tone (some European
countries), requires B0 setting.
&G2 1800 Hz guard tone (U.K.), requires
B0 setting.
&Hn Sets Transmit Data (TD) flow control
&H0 Flow control disabled
* &H1 Hardware flow control, Clear to
Send (CTS)
&H2 Software flow control, XON/XOFF
&H3 Hardware and software control
&In Sets Receive Data (RD) software flow control
(see also &Rn).
* &I0
Software flow control disabled
&I1 XON/XOFF signals to your modem and
remote system
&I2 XON/XOFF signals to your modem only
&Kn Enables/disables data compression.
&K0 Data compression disabled
* &K1 Auto enable/disable
&K2 Data compression enabled
&K3 MNP5 compression disabled
&Mn Sets Error Control (ARQ) for connections at 1200 bps
and higher.
&M0 Normal mode, error control disabled
&M1 Reserved
&M2 Reserved
&M3 Reserved
* &M4 Normal/ARQ
&M5 ARQ mode
Page 12
RMM User’s Guide